Datasheet

Camtec Power Supplies GmbH – Gewerbestrasse 30 – D-76327 Pfinztal – Germany p.8/8 (12.2017.02.0)
Phone [phone] - Fax [phone] – www.camtec-gmbh.com - [e-mail]
(Subject to alterations. This product is not designed to be used in applications such as life support systems wherein a failure or malfunction could result in injury or death)
Ordering Information
Output Type (DIN-Rail standard) Part Number Remarks
0-15V HSEureg04801.015T 3041051001CA
0-30V HSEureg04801.030T 3041051002CA
0-50V HSEureg04801.050T 3041051003CA
0-90V HSEureg04801.090T 3041051004CA
0-130V HSEureg04801.130T 3041051005CA
0-180V HSEureg04801.180T 3041051006CA
Option Screw Terminal Plug 3520037 for the pack Optional Plug for the interface, 2 poles LS5,08 180°cabling, (10pcs each pack)
Option ADTW201 3041090001CA Optional DC-repeater 1:1 with no losses for save interface separation >60Vdc
Option Protective Coating - Ask for technical support and personal quote from your retailer
Safety regulations
:
Please read these instructions
completely
before using
the equipment
.
Keep these
instructions
on
to hand.
The device may only be operated by trained specialist staff.
Installation:
1) The device is designed for devices and systems
that meet the standard requirements for hazardous
voltages, power and fire prevention.
2.) Installation and service only by trained persons.
The AC power must be switched off. The work is to be
labeled; accidental reconnection of the system must
be prevented.
3.) Opening the device, its modification, loosening
bolts or operation outside the specified herein
specification or in an unsuitable environment, has the
immediate loss of warranty to follow. We disclaim any
responsibility for any resulting damage to persons or
things.
4.) Note: The device must not be operated without an
upstream circuit breaker (CB). We recommend the use
of B-Type 16A. It is prohibited to use the unit without
PE. It may be necessary upstream device has a power
switch.
Warning:
Non-compliance can result in fire and serious injury or death.
1. Operate the appliance without PE connection.
2. Before connecting the device to the AC network,
make wires free of voltage and assure accidently
switch on.
3. Allow neat and professional cabling.
4. Never open nor try to repair the unit. Inside are
dangerous voltages that can acause electrical shock
hazard.
5. Avoid metal pieces or other cunductive material to
fall into the item
6. Do not operate the device in damp or wet
conditions
7. Do not operate the unit under EX-conditions
All parameters base on 15 minutes run-in @ full load / 25°C / 230Vac 50/60Hz, as otherwise stated.