User manual

IP Telephone User Guide
65
Step 4 – Firmware update complete
If the firmware update is successful you will see the following window:
Click the here link to reboot the device and start using the new software.
Diagnostic messages
From the web pages
The device can run through a series of self-tests to check that every part
of the system is working correctly. The tests include:
Perform a network check of all network connections, including the:

Gateway and DNS Gateway.

LAN port and PC port check

DHCP server check

NAT check

VoIP Account information check
To perform the diagnostic checks, follow the procedure below:

Select the Flexor 500 option from the main management web page.

Click on the Diagnostics link at the top of the window.

After a short pause while the checks are run a window is displayed
containing a report about all the checks that have been run.
Normally, there should be no problems reported.