User manual

IP Telephone User Guide
63
first starts up. This deletes all settings including any SIP account details
and address book entries.
Upgrading the firmware
During the firmware update you must not remove power from
the Flexor 500, or damage could occur. Use the menu or web
page options to reboot the device. Do not remove the power
cable. When in doubt, wait several minutes to let the unit go
idle before removing the power.
From time to time new firmware upgrades will become available for your
Flexor 500 which can be downloaded over the Internet and then installed
on the device.
The screen will indicate when there is new firmware if it is working
correctly and there is no call activity. See Firmware on page 40 for details
of installing firmware updates directly from the device.
From the web pages you can check if there is a firmware update available
and if there is an update you can download and install the firmware on the
device.
Alternatively you may receive a new firmware notification in the messages
area, as shown below:
In this case click here in the sentence Click here for more information and
proceed straight to step 2.
To manually check for firmware updates, follow the procedure below:
Step 1 – Check for firmware updates

Select the Flexor 500 option from the main management web page.

Click on the here link on the ‘Please click here
to check for firmware
updates’ line on the web page.

If the firmware is up to date the following window is displayed:

Click Next > to return to the main menu.

If the firmware needs updating the following window is displayed:

Click Next > and proceed to step 2.
W
arning