User manual

IP Telephone User Guide
20
Click on Next >. Now enter your VoIP account details:
Your ITSP should have provided you with a user name and password,
either by email or by post. Enter these details along with (optionally) your
own name.
Click on Finish. A message is displayed briefly, informing you that the
device is contacting your ITSP to verify your account details.
Click on Return Home. The home page is displayed with a message
informing you that the device is connected and working properly:
Setup complete
The above steps are the only configuration tasks that are required in order
to begin using your Flexor 500. You should now be able to make telephone
calls.
For more information about the Flexor 500 management web pages refer
to
Managing the device using web pages on page 30 .
Testing your setup
Once you have connected the device and configured it you should check
the following to ensure that everything is working correctly.
Firstly, if the time is shown correctly this indicates that the device has
managed to access the internet to read the current time.
When your telephone is configured with a valid ITSP at least one of the line
buttons should be illuminated in green. This indicates that you have a line
available to make and receive calls.