Specifications

!
14!
Timer$
!
!
The!Timer!tab!allows!the!use!of!the!CamRanger!as!an!intervalometer!as!well!as!specifying!
exposure!times!when!the!camera!is!in!bulb!mode.!
Time$Lapse$
• The!entry!fields!are!used!to!specify!the!initial!delay!before!the!first!shot,!the!number!
of!shots!to!take,!and!the!delay!in!between!each!shot.!
• After!configuring!the!settings,!press!the!“Start”!button!to!begin!the!intervalometer!
process.!
• The!intervalometer!commands!are!stored!on!the!CamRanger!unit!and!the!Android!
device!does!not!need!to!remain!on!or!connected.!
• The!“Shot!Delay”!should!not!be!used!for!precision!timing,!particularly!when!the!
delay!is!only!a!few!seconds!or!less.!
• Once!an!intervalometer!sequence!is!begun,!it!can!only!be!cancelled!by!turning!off!
power!to!the!CamRanger!device.!
• Time!Lapse!–!Bulb!
o If!the!camera!is!in!bulb!mode/shutter!speed!and!the!camera!supports!bulb!
shots,!CamRanger!will!take!Bulb!shots!during!the!time!lapse.!The!bulb!
duration!is!specified!by!the!Shot!Duration,!located!within!the!Bulb!section!
immediately!below!the!Time!Lapse!section.!
• Before!starting!the!time!lapse!sequence,!a!dialog!will!appear!informing!the!user!of!
the!time!lapse!parameters!and!provide!an!opportunity!to!cancel.!
Bulb$
• The!Bulb!controls!are!only!enabled!when!the!camera!is!in!bulb!mode!and!the!camera!
supports!remote!bulb!shots.!Note:!for!some!cameras,!bulb!mode!is!set!by!changing!
the!shutter!speed!to!“bulb.”!
• The!entry!fields!are!used!to!specify!the!initial!delay!before!the!first!shot!and!the!
length!of!the!exposure.!
• After!configuration,!press!the!“Start”!button!to!begin!the!bulb!process.!
• The!bulb!commands!are!stored!on!the!CamRanger!device!and!the!Android!device!
does!not!need!to!remain!on!or!connected.!