Datasheet

21
Manual
PC208W Datalogger Support Software
Step A7: Select the COM Port settings corresponding to the serial port used by the “9 to 9 pin” computer cable
connecting the SC532A Interface (see paragraph 3.1). In most cases this will be either COM1 or COM2.
Step A8: Set Baud Rate at 19200. This is a measure of the communication speed between PC and Storage Module. In
case frequent communication problems are experienced, lower the Baud Rate and see if this solves the problem.
Step A9: Click the “Connect” button to connect SM4M or SM192 to PC.
If communication is successfully established, a window similar to the one below appears. Note that the status box
is no longer empty and is now containing information on the module’s memory.