Product manual

SDM-CAN Datalogger-to-CANbus Interface

For downloading software you will need the following:

• Device Configuration Utility (DevConfig), which is bundled with

PC400 and LoggerNet datalogger support software. It is also

available at no charge from www.campbellsci.com/downloads.

• A copy of the SDM-CAN operating system (copied to your hard-disk)

• A PC running Microsoft Windows

• A null-modem cable that connects the RS-232 port on the SDM-CAN

to a serial port on your PC

The SDM-CAN also requires a 12V power supply, but does not have to be

connected to a datalogger.

To load the new operating system take the following steps:

• Run DevConfig and select SDM-CAN for the device type.

• Follow the instructions presented in DevConfig.

• Wait until the process has completely finished and reports a successful

upgrade before removing power from the SDM-CAN or quitting

DevConfig.

6. Attributions

Microsoft and Windows are either registered trademarks or trademarks of

Microsoft Corporation in the United States and/or other countries.

Primary content of this manual is used by permission and is consistent with the

publication SDM-CAN CAN-Bus Interface User Guide, Issued 26.6.07.

Adaptations of technical content are indicted by shading.