Specifications

Section 2. Hardware Installation
3. Use the 2.125 stainless steel U-bolt to attach the adjustable angle
mounting bracket to the pole. Depending on the size of the antenna
position the bracket directly below, or above, the enclosure top mounting
bracket. The top of an omni directional antenna should not be higher than
the top of the lightning rod.
Slide the U-bolt behind the pole and through the oval notches on the
adjustable angle mounting bracket (see Figure 2.5-9). Put a flat washer,
lock washer, and a silicon bronze nut, in that order, on the ends of the U-
bolt. Tighten the nuts finger tight to allow the angle bracket to rotate
around the pole.
FIGURE 2.5-9. Slide Antenna Bracket U-Bolt around Back of the Pole
2-35