Specifications

Section 2. Hardware Installation
2.5.4.3 Internal Installation
If the RF450 radio was ordered with the ET107, you can skip
this section and go directly to the External Installation section.
NOTE
The following components are provided in the RF450 radio kit for installation
inside the ET enclosure:
(1) 18327 RF450 900MHz 1 W Spread Spectrum Radio
(1) 20584 RF450 ET Enclosure Antenna Cable
(1) 20585 RF450 ET Enclosure Mounting Bracket
The radio comes mounted to the ET bracket. Install the assembly as follows.
Power the station down by flipping the PS100 power switch to
“Off” before installing any communication option. Remember to
flip the switch back to “On” after enclosure installation is
completed.
NOTE
1. Mount the RF450 bracket and radio into the ET enclosure using the three
existing screws. See Figure 2.5-5.
2. Thread the smaller SMA connector end of the enclosure antenna cable
underneath the battery cables and screw it to the RF antenna connector on
the RF450 radio. Attach the other end of the cable to the BNC RF
bulkhead connector in the lower right hand corner of the enclosure. Make
sure all connections are tight. See Figure 2.5-5.
FIGURE 2.5-5. RF450 in ET107 (battery not shown)
10588 Ribbon Cable
Antenna Cable
2-32