Specifications

Section 2. Hardware Installation
serial cable. The CR1000 datalogger used in the ET107 station can speak with
more than one device at a time allowing troubleshooting to be done in the field
with a laptop while remote communication devices are accessing the station.
It’s best to use Device Configuration Utility (DevConfig) and
connect directly to the station to change the CR1000
configuration. DevConfig is included with LoggerNet and can
be obtained, at no charge, from our website.
NOTE
Connects with
phone modem’s
RJ-11 patch cord
Connects with a
phone modem, Rad
modem, or RF450
radio via the 10588
ribbon cable
Connects with Rad
modem’s 4-wire
patch cable
Connects with a
laptop via an RS-232
serial cable
FIGURE 2.5-1. Close-up of the terminals and 9-pin ports in the ET107 (battery not shown).
2-25