Specifications

Section 2. Hardware Installation
2.4.10 Sensor Connections
Sensor schematics are provided in Section 4.3.1.
1. Each sensor cable plug attaches to a unique bulkhead connector as shown
in Figure 2.4-17. The sensor cables are individually marked to match up
with the sensor labeling on the back of the enclosure.
The 034B Wind Sensor plugs into the connector
labeled WS/WD. Plugging this sensor in the connector
labeled SDI-12 may damage the sensor and/or the main
enclosure connector board.
WARNING
Enclosure Ground Lug
Wire Tie Harness
Sensors
TEMP CS616
WS/WD
SDI-12
TEMP/SONIC
RAIN (PRECIP)
TEMP/RH
SOLAR RADIATION
COMM
POWER
BNC Coaxial
Connector
Standoff
FIGURE 2.4-17. Position of Sensor Bulkhead Connectors
2-22