Specifications

Section 2. Hardware Installation
Temp/RH with
Cap Removed
FIGURE 2.4-3. Temperature/Relative Humidity Sensor
without Yellow Protective Cap
3. Insert the temperature/relative humidity into the gill radiation shield until
it stops or a “click” is heard.
4. Attach the gill radiation shield to the underside of the crossarm using the
two Phillips screws from step 1.
2.4.4 034B Wind Sensor (Wind Sensor Option –MW)
1. Install the 034B Wind Sensor as shown in Figure 2.4-4 after the sensor
arm is securely installed.
Plugging this sensor into the connector marked “SDI
12” can result in damaging this sensor, the main
enclosure connector board, or both.
WARNING
2-11