Specifications

Section 1. Preparation and Siting
1.2 Installation Tasks
1.2.1 Indoors
• Immediately upon receipt of your shipment…
⇒ Weather station is packed in the shipping box in layers. See Figures
1.2-1A, 1.2-1B, 1.2-2, and 1.2-3.
⇒ Immediately upon receipt of your shipment…
Open shipping carton(s).
Set the large weather station carton down lengthwise on a floor or
table top. Position the box as shown in Figure 1.2-1A.
Cut the tape along the edge of the lower flap first. See Figure 1.2-
1A.
Cut the tape around the remaining flaps BUT only cut one layer deep.
Lift up the cardboard flaps exposing the top layer of foam as shown
in Figure 1.2-1B.
⇒ Check contents against invoice and shipping checklist. Contact CSI
immediately about any shortages.
THIS SIDE UP
Cut Lower Flap
Edge First
FIGURE 1.2-1A. Cut Flap Packing Tape
tto
Top Packing
Foam Layer
Middle Packing
Foam Layer
ET107,
Top Layer
ET107,
Bo m Layer
Bottom Packing
Foam Layer
FIGURE 1.2-1B. Shipping Box Packaging
1-3