Instruction manual

WS-PRO2 Weather Station Manual

27176

Page 49 of 61

the U-bolt. Tighten up the U-bolt to hold the sensor firmly. Plug the cable

into the mating connector on the sensor. Plug must be fully seated and

locking ring turned fully clockwise.

4. Install the wind vane using the Allen wrench supplied with the vane.

Wind vane should be perpendicular to the cross-arm. Put the sticker over

the wind vane Allen screw opening.

5. Remove and keep the shoulder screw. The shoulder screw will be

needed for replacing bearings and/or potentiometer. The wind vane and

cups should turn freely.