Instruction manual

WS-PRO2 Weather Station Manual
GT
27176
Page 48 of 61
Figure 34
WARNING
The wind vane can be easily damaged if dropped or bent. Leave the
wind vane in the protective cardboard sleeve until it’s ready to be
installed.
1. Remove the alignment screw at the base of the Wind Sensor (Figure
34). Insert the Wind Sensor into the Mounting Shaft. Align the hole in the
shaft with that in the base and replace the screw. Do not over tighten the
alignment screw. Do not remove the shoulder screw at this time.
2. Insert the mounting shaft through the U-Bolt on the sensor arm. Adjust
the mounting shaft so that the cable and connector coming out the end of
the sensor arm can plug easily into the mating connector on the wind
sensor. Lightly tighten up the U-bolt clamp nuts. See Figure 33.
3. See Figure 34 for the alignment sticker on the wind sensor. Align the
arrow on this sticker with True South. The counterweight will also be
pointing due south. Make sure the sensor cable is not being pinched by
UTION
ENTIOMETER
ENT 5mA
FACE SOUTH
Shoulder
Screw
South
Alignment
Sticker
Alignment
Screw
UTION
ENTIOMETER
ENT 5mA
FACE SOUTH
Shoulder
Screw
South
Alignment
Sticker
Alignment
Screw