Instruction manual

WS-PRO2 Weather Station Manual
GT
27176
Page 38 of 61
4.2.1 Phone Modems
If you received a telecommunication kit separate from the ET Enclosure,
follow the "Internal Installation" procedures outlined in later sections.
Figure 26
4.2.1.0 Internal Installation
For installation inside the WS-PRO2 Enclosure, the following
components are provided in the phone modem kit:
(1) COM220 Phone Modem
(1) 12 inch RJ-11 Patch Cord
(1) Mounting Bracket
(4) Screws
(1) 12 inch 14 AWG Ground Wire
Install the phone modem as shown in Figure 26.
1. Attach the modem to the modem bracket with the 2 screws
provided. Mount the modem and bracket into the WS-PRO2
Enclosure with the 3 pre-threaded screws on the mounting
plate.
2. Connect the modem 9-pin port to the WS-PRO2 Enclosure
port with the P/N 10588 ribbon cable supplied with the ET
Enclosure.
3. Connect the modem RJ-ll jack to the WS-PRO2 Enclosure
RJ-11 jack with the RJ-ll patch cord.
4. Connect the modem ground port to the WS-PRO2 Enclosure
ground with the 14 AWG ground wire.
4.2.1.1 External Installation
The following modem kit components are used to make the
external connections: