Instruction manual

WS-PRO2 Weather Station Manual
GT
27176
Page 27 of 61
4.1.0 Enclosure, Datalogger, Power Supply
4.1.1 Battery Installation
Figure 16
The PS100 power switch should be in the “OFF” position. To install the
battery, remove the cover from the PS100 by sliding the latch up at one
end of the cover and sliding the cover down and out. Install the battery as
shown in Figure 16. Plug the battery lead into the connector labeled
“BATTERY – Internal 12V 7 Amp-Hour”. Put the cover back on the PS100
and latch it in place.
NOTE: Do not switch the power supply to “on” until AC or solar power has
been connected to the back of the enclosure.
The red charge light on the PS100 will glow when charging voltage is
present. The charge light is not affected by the switch. Switching on the
power supply without a charging voltage will run the battery down.
Figure 17 shows factory wiring between the PS100 and the enclosure.