Instruction manual

WS-PRO2 Weather Station Manual
GT
27176
Page 17 of 61
Figure 11
3.1.0 Base Tower Components
3.1.0.1 Supplied Components
(1) Upper Tower Section (Tapered)
(1) Lower Tower Section
(6) ½ inch Washers
(1) 12 foot 10 AWG Ground Cable
(1) Tower Cap
(1) 20' communications cable
(1) 20' power cable
Refer to Section 2 for components supplied by installer.
3.1.1 Tower Installation
Attach the tower to the base as shown in Figure 12.
1. Dig a hole close to the concrete base to access the lower conduit
opening. From the hole, trench to the power and communications
sources. Remove the duct tape from both ends of the conduit.
2. Remove the template. Attach the two pieces of the tower. This is a
permanent connection and cannot be undone. Lay the tower on
the ground with the base next to the concrete foundation.
3. Thread communications and power cables through the tower and
conduit. Electrical tape will help.
SIDE VIEW
TOP VIEW
ANCHOR BOLT
FORM
FORM WIRE
CEMENT PAD
SMALL
CAVITY
2
4"
24"
24"
TEMPLATE
2"
NORTH
FORM WIRE