Product manual

RAWS-H Remote Automated Weather Station
FIGURE 5.4-1. GOES Transmitter
5.4.2 Wiring, GOES Transmitter (part #TX320)
The GOES transmitter (part #TX320) is mounted inside the RAWS
environmental enclosure and the transmitter connections are described below;
GOES Transmitter TX320 Connection inside the RAWS environmental
enclosure
GOES TX320 “CSI/O” Port --to-- CR1000 PC Board “CSI/O” Port using
an *SC12 Cable
GOES TX320 “GPS Port” --to-- GPS Antenna Cable
GOES TX320 “RF Out” --to-- GOES Antenna Cable
GOES TX320 “Power Port” --to-- Battery Cable Junction Connector
*Note: The SC12 Cable ships with the RAWS Weather Station.
5.4.3 Troubleshooting, GOES Transmitter (part #TX320)
If a problem with the GOES transmitter (part #TX320) is suspected, the TX320
may be checked by measuring the +12 V and Ground terminal on the CR1000
PC-board wiring panel. Acceptable readings are +11 VDC to +14 VDC.
Check the SC12 cable connection between the CR1000 wiring panel and the
TX320. Press the TX320 diagnostic button to query the state of the
transmitter.
10