Specifications

RAWS-F Remote Automated Weather Station for Fire Weather

FIGURE 5.6-1. CR1000 Keyboard/Display

5.6.2 Wiring, CR1000 Keyboard/Display (part #CR1000KD)

The CR1000 Keyboard/Display (part #CR1000KD) connects to the CR1000

PC board “CS I/O” 9-Pin connector using our CS I/O serial cable (part #10873)

that ships with the RAWS station.

5.6.3 Maintenance, CR1000 Keyboard/Display (part #CR1000KD)

There are no user-serviceable parts on the CR1000KD. No maintenance is

required.

5.6.4 Calibration, CR1000 Keyboard/Display (part #CR1000KD)

No calibration is required.

5.6.5 Troubleshooting, CR1000 Keyboard/Display (part #CR1000KD)

If a problem with the CR1000 Keyboard/Display is suspected, the CR1000KD

may be checked by connecting the CR1000KD to the CR1000 PC board 9-Pin

“CS I/O” connector using our CS I/O serial cable (part #10873). The

CR1000KD display should be visible. Check the CH100 on/off switch. If the

display is not visible, check the CR1000 wiring panel for 12 Volt power. If the

CR1000 is unresponsive to CR1000KD key strokes, then there might be a

problem with the CR1000 datalogger. If problems persist, try a substitute.

Obtain a Return Material Authorization (RMA) number before returning this

equipment to Campbell Scientific for repair.

5.7 CR1000 Datalogger (part #CR1000)

5.7.1 General Description, CR1000 Datalogger (part #CR1000)

The CR1000 shown in Figure 5.7-1 provides sensor measurement,

timekeeping, data reduction, data/program storage and control

functions. The RAWS Quick Deployment CR1000 datalogger