User guide

Raven EDGE/GPRS for Cingular - User Guide, version 2.31 91
AT Commands: Telemetry and Addr List (Address List)
FIGURE 3. Addr List
IPL=n
MLISTid=d.d.d.d
MLISTXhexid=d.d.d.
d
MVLEN=n
IP List Dial
This allows access the Modbus IP list using the first two digits of the dial string. Example:
ATDT1234567 would go to ID "12" on the Modbus list and use the associated IP as the destination.
n=0 : Disabled
n=1 : Enabled
This command is configured by the fields avaialble in the Addr List group.
Enters an ID and IP address into t
he Modbus List. ID is a decimal value (1 to 100).
id=ID
d.d.d.d=IP or nam
e adresse
This command is configured by the fields avaialble in the Addr List group.
Enters an ID and IP address into the Modbus List. ID is a hexadecimal value (0 to 64).
hexid=ID
d.d.d.d=IP or nam
e adresse
Mod
bus Variant ID Length: Length of the RTU ID in a modbus-variant protocol, in bytes.