User guide

Raven EDGE/GPRS for Cingular - User Guide, version 2.31 67
AT Commands: Serial
S5=n
S6=n
S23=[speed],[databits][p
arity][stop bits]
S50=n
S51=n
The standard line feed character sent
by the modem to the host at the end of a response or
return code in command state.
Cannot be configured in Wireless Ace.
Backspace Character
n=0-127 (ASCII character number )
This register sets the character recognized as a backspace during command entry.
Cannot be configured in Wireless Ace.
Wait for Blind Dial
n=2-10 seconds
This register denotes the wait time, in seconds, before a blind dial (no dial tone detection).
Cannot be configured in Wireless Ace.
Serial line parameters. The settings take affect after reset.
speed=30
0 | 1200 | 2400 | 4800 | 9600 | 19200 | 38400 | 57600 | 115200 | 230400
dat
abits=7 or 8
parity=O : Od
d
pari
ty=E : Even
pari
ty=N : None
parity=M: Mark
stopbits=1
| 1.5 | 2
Example: ATS23=19200,8N1
(sets modem to 19200, etc.)
Can also be set using &L=[spee
d],[databits] [parity][stop bits]
Note: Databits MUST be 8 data bits for PPP mode.
Data forwarding idle time-out. If set to 0, a forwarding time-out of 10ms is used.
n=tenths of seconds
Used in UDP or TCP PAD mode.
PAD data forwarding character.
n=ASCII code of character that will cause data to be forwarded.