User guide

Raven EDGE/GPRS for Cingular - User Guide, version 2.31 7
Activation of the Raven
Most Cingular accounts use the default addressing solution of Private or Public IP addresses sup-
plied by the Internet and Proxy APNs. Only if you have a S
tatic or Custom IP address should you
need to configure a custom APNs.
To configure the APN, you need to use Wireless Ace. If
yo
u haven't installed Wireless Ace refer to
the "software required" section on page 1 of this guide.
A. Click on Connect.
FIGURE 6. Wireless Ace: Connect
FIGURE 7. Wireless Ace: EDGE/HSDPA
1.
Powere on your Raven and connect directly to the serial port on your computer.
2.
Start Wireless Ace and connect to your modem.
Start > All Programs > AirLink Communications > Wireless Ace 3G > Wireless Ace 3G
B. Select PPP.
C. Select the COM port to which the modem is connected on your computer (commonly COM1).
D. Type in the modem’s password (default 12345).
3.
Select EDGE/HSDPA from the menu on the left side of Wireless Ace (under “Groups”).
4.
Type in the APN in the new value field of *NETAPN.