Specifications

RavenXTG Sierra Wireless Cellular Modem

Baud rate changes require the modem to be reset before the

change takes affect. Click the Reset icon in AceManager to the

reset the modem and implement the change.

NOTE

Verify the APN has been entered in the NETAPN and +CGDCONT fields as

shown above (where I2GOLD is the APN).

e. If an SC105 interface is used, its default baud rate of 9600 will have to be

changed to match the baud rate of the modem (using CSI’s DevConfig

utility).

f. Check the Network light. Network – indicates a successful connection to

the cellular network with an IP Address given and a channel acquired.

g. Make sure the modem has sufficient power.

h. Check the signal strength (make sure your antenna is properly connected

and oriented). Signal strength should be in the -51 to -90 range (-51 is a

strong signal, -90 is a weak signal).

i. If you have a Static IP account, verify the Static IP Address. Preceding

zeros in the IP address are not entered in LoggerNet/PC400.

j. If you have a Dynamic IP account, you will need to have a DDNS

(dynamic domain name server) name that LoggerNet can reference to

make the connection (Section 5).

k. Connect with the modem through the serial port using AceManager. If the

modem has been configured for “PPP” (see appendix B), then you may

have to check the “Use SOS Mode” box.

From the “Status” group, make sure the “Network State” is “Network

Ready”, and note the “Network IP” address. This is the current IP address

for the modem (a dynamic IP address may change when the modem is

reset). Try connecting to this IP address using LoggerNet. If LoggerNet