Instruction manual

Appendix C. Configuring the Raven XT-Rogers for PPP
Use AceManager to configure the following Misc setting:
• DPort = 3001 (Changed from 6785)
This setting change allows information to be passed from loggernet to the
the Datalogger. If we were to leave the DPort setting at 6785 the Raven
XT-Rogers would trap the information as its own and Loggernet will show
an error of “Connection Refused” when you try to connect to the
Datalogger. Ensure that the Loggernet port setting is left as 6785, so that
the modem will function in PPP mode.
Use AceManager to configure the following UDP setting:
• MD = 02-PPP (Changed from 00 — Normal, AT command)
After the changes have been made, click the Write icon to save the changes in
the modem
.
Click the Reset icon to restart the modem. The other ways to reset the modem
are by pressing the reset button on the front of the modem or removing the
power from the modem.
Click the Disconnect icon to terminate communications with the modem.
Datalogger Settings:
Using the Device Configuration Utility, configure the following setting on the
TCP/IP tab:
• Config Port Used = RS232
• IP Address = 0.0.0.0
• Modem Dial String = PPP
• Modem Dial Response = CONNECT
• User Name and Password are blank
C-2