Product manual

Appendix D. NL200 Driver Installation Instructions
D.2 Installing on Windows Vista
1. Before you plug the NL200 into a computer USB port, you must first run
the install utility on the NL200 install disc. This will ensure that the driver
files are copied where the operating system can find them.
2. Connect a USB cable to the NL200 USB port and one of your computer's
USB ports.
3. After some delay, your computer should display a dialog similar to that
shown below:
4. Select the option to Locate and install driver software (recommended).
Because the NL200 driver is not signed, the following will be displayed:
5. Select the option to Install this driver anyway. At this point, the driver
should be installed and the NL200 will be ready to configure and use.
D-3