Product manual

Appendix C. NL200 Settings
DHCP
Enable if the device should be configured to use DHCP (Dynamic Host
Configuration Protocol) to automatically acquire an IP address, subnet mask,
and gateway from the local DHCP server. After DHCP is enabled the device
will reboot and it may take a few moments to acquire the IP settings. In order
to see the acquired settings you may have to do a refresh by hitting F5.
IP Address
The IP address uniquely identifies this node on an internet. If DHCP is
enabled, this is the IP address obtained from the DHCP server. If DHCP is
disabled, a static IP address must be obtained from your network administrator
for use with this device. (It is recommended to configure a static IP address.)
In Bridge mode this setting is obtained from the datalogger and
cannot be edited here. It must be edited in the datalogger
settings. If the setting has been successfully obtained from the
datalogger this setting will show "OK" otherwise it will show
"0.0.0.0"
NOTE
Subnet Mask
The Subnet Mask is used to select that portion of the IP address which
identifies the network. It is used to facilitate routing and should be obtained
from the network administrator along with the IP address. If DHCP is enabled,
this is the Subnet Mask obtained from the DCHP server.
In Bridge mode this setting is obtained from the datalogger and
cannot be edited here. It must be edited in the datalogger
settings. If the setting has been successfully obtained from the
datalogger this setting will show "OK" otherwise it will show
"0.0.0.0"
NOTE
Default Gateway
Datagrams being sent to an unknown network are routed via the Default
Gateway. This entry specifies the Internet address of the Default Gateway. If
no Default Gateway exists, set this entry to "0.0.0.0". If DHCP is enabled, this
is the Default Gateway obtained from the DCHP server.
In Bridge mode this setting is obtained from the datalogger and
cannot be edited here. It must be edited in the datalogger
settings. If the setting has been successfully obtained from the
datalogger this setting will show "OK" otherwise it will show
"0.0.0.0"
NOTE
C-2