Product manual

NL200 Network Link Interface
7.2.3 LoggerNet Set-up
The next step is to run LoggerNet and configure it to connect to the datalogger
via the Ethernet port. (See example in Figure 7-2 below.)
• In LoggerNet’s Setup Screen, press Add Root and choose IPPort. Input
the NL200’s IP address and port number. The IP address and port number
are input on the same line separated by a colon.
• Add a PakBus Port.
• Add the datalogger and input the PakBus address of the datalogger.
• Press Apply to save the changes.
• You can verify your settings are correct by selecting the datalogger in the
Network Map, selecting the Clock tab, and pressing “Check Clocks”. If
your settings are correct, you should see the current clock of your server
and datalogger.
FIGURE 7-2. Serial Server LoggerNet Setup
14