Product manual

NL200 Network Link Interface

• Open DevConfig.

• Under Device Type, select “NL200”.

• Click the browse button next to “Communication Port”.

• Select the port labeled “NL200”.

• Click “OK”.

• Click “Connect”.

• Configure the NL200 as needed for your application.

• Click “Apply” to save your changes.

6.3 Configuring the NL200 via Telnet

The NL200 must have an IP address before connecting via

Telnet. You will need to configure your NL200 via USB or

Network Connection with DHCP the first time it is set up.

Telnet is not available in Bridge Mode.

NOTE

• Ensure the NL200 is powered and connected to your network.

• Type Telnet <NL200 IP address> at a command prompt. (If you have

changed the NL200’s Telnet Port Number from its default value of 23, you

will need to append this to the IP address with a space. For example, if the

Telnet Port Number has been changed to 40, type: Telnet 192.168.12.144

<space> 40.)

• Input the NL200 Admin Password (default password is nl200).

• Type help to see a list of the functionality available when connected to the

NL200 through telnet.

• Type edit and press Enter to edit the settings of the NL200.

• As each NL200 setting is shown, press Enter to accept the current value

shown in parenthesis. Type a new value and press Enter to change the

value.

• After progressing through all of the NL200 settings, type Save to accept

the changes or Cancel to discard the changes.

• Type bye to exit Telnet.