Product manual

NL200 Network Link Interface

6. Configuring the NL200

The NL200 is configured using the Device Configuration Utility (DevConfig).

You can connect your NL200 to DevConfig using either a network connection

or USB.

6.1 Configuring the NL200 via Network Connection

The NL200 must have an IP address before connecting via a

network connection. If the address cannot be obtained via

DHCP, you will need to configure your NL200 via USB the first

time it is set up.

NOTES

When the NL200 is in Bridge Mode, it can not be configured via

a network connection. It can only be configured via USB.

• Ensure the NL200 is powered and connected to your network.

• Launch DevConfig.

• Under Device Type, select “NL200”.

• Check the box labeled “Use IP Connection”.

• Click the browse button next to “Communication Port”.

• Select the NL200 to be configured from the resulting pop-up window.

• Enter “NL200” in the TCP Password box. (“NL200” is the default

administrative password. It can be changed via the DevConfig

Deployment/NL200 tab.)

• Click “OK”.

• Click “Connect”.

• Configure the NL200 as needed for your application.

• Click “Apply” to save your changes.

6.2 Configuring the NL200 via USB

INSTALL the DEVICE DRIVER BEFORE plugging the NL200

into your PC for the first time. You will need the device driver

properly installed before you can connect to the NL200 via USB.

See Appendix D for instructions on installing the device driver.

NOTE

• Ensure the NL200 is powered.

• Connect the supplied USB cable between a USB port on your computer

and the USB port on the NL200.