Instruction manual

NL200/201 Network Link Interface

• Click OK.

• Click Connect.

• Configure the NL200/201 as needed for your application.

• Click Apply to save your changes.

6.2 Configuring the NL200/201 via Network Connection

The NL200/201 must have an IP address before connecting via a

network connection. If the address cannot be obtained via DHCP,

you will need to configure your NL200/201 via USB the first time

it is set up.

• Ensure the NL200/201 is powered and connected to your network.

• Launch DevConfig.

• Under Device Type, select NL200.

• Check the box labeled Use IP Connection.

• Click the Browse button next to Communication Port.

• Select the NL200/NL201 to be configured from the resulting pop-up

window.

• Enter nl200 in the TCP Password box. (nl200 is the default administrative

password. It can be changed via the DevConfig Deployment/NL200 tab.)

• Click OK.

• Click Connect.

• Configure the NL200/201 as needed for your application.

• Click Apply to save your changes.

6.3 Configuring the NL200/201 via Telnet

The NL200/201 must have an IP address before connecting via

Telnet. Configuration via Telnet is not available in bridge mode.

• Ensure the NL200/201 is powered and connected to your network.

• Create a Telnet session with the device over port 23.

• Input the NL200/201 Admin Password (default password is nl200).

• Type help to see a list of the functionality available when connected to the

NL200/201 through Telnet.

NOTE