Operator`s manual

Manual

4: Do (P86)

1: 41 Set Port 1 High

;CONTROL PORT1 IS CONNECTED WITH A JUMPER TO SW12CTRL

;(SWITCHED 12 VOLT CONTROL)

5: Excitation with Delay (P22)

1: 3 Ex Channel

2: 0 Delay W/Ex (units = 0.01 sec)

3: 10 Delay After Ex (units = 0.01 sec)

4: 0 mV Excitation

;DELAY OF 0.1 SEC TO ALLOW CS500 TO WARM UP AND STABILIZE

;INSTRUCTION (P22) ONLY SERVES FOR DELAYING THE PROGRAM

;NO ACTUAL EXITATION IS NEEDED. E3 IS NOT WIRED

6: Volt (SE) (P1)

1: 1 Reps

2: 5 2500 mV Slow Range

3: 1 SE Channel

4: 1 Loc [ AIR_TEMP ]

5: 0.1 Mult

6: -40 Offset

;TEMPERATURE MEASUREMENT WITH CS500 SENSOR, CONNECTED TO SINGLE

;ENDED CHANNEL 1. TEMPERATURE MEASURED IN DEGREES CELSIUS.

7: Volt (SE) (P1)

1: 1 Reps

2: 5 2500 mV Slow Range

3: 2 SE Channel

4: 2 Loc [ RH ]

5: 0.1 Mult

6: 0.0 Offset

;RELATIVE HUMIDITY MEASUREMENT WITH CS500 SENSOR, CONNECTED TO

;SINGLE ENDED CHANNEL 2. RH MEASURED IN PERCENTAGE.

8: Do (P86)

1: 51 Set Port 1 Low

;SWITCH OFF CS500

9: Volt (Diff) (P2)

1: 1 Reps

2: 2 7.5 mV Slow Range

3: 2 DIFF Channel

4: 3 Loc [ SOLAR_RAD ]

5: 200 Mult

6: 0.0 Offset

;INCOMMING SOLAR RADIATION MEASUREMENT WITH LI200X SENSOR, CONNECTED

;TO DIFFERENTIAL CHANNEL 2.

;THE OUTPUT FROM LI200X IS 0.2 kW/M2, mV. MAXIMUM INCOMING SHORTWAVE SOLAR

Annexes