Instruction manual

Met One 034B Wind Set

FIGURE 4-2. CM200 Series Crossarm with CM220 Right Angle

Mounting Bracket

4.2 Step 2—Use Short Cut to Program Datalogger and

Generate Wiring Diagram

Short Cut is an easy way to program the datalogger to measure the 034B and

assign terminals. The following procedure shows using Short Cut to program

the 034B.

1. Install Short Cut by clicking on the install file icon. Get the install file

from either www.campbellsci.com, the ResourceDVD, or find it in

installations of LoggerNet, PC200W, PC400, or RTDAQ software.

2. The Short Cut installation should place a Short Cut icon on the

desktop of your computer. To open Short Cut, click on this icon.

CM220

CM200 Series Crossarm