Instruction manual

SECTION 5. STG MODULE: SMS - STORAGE MODULE SOFTWARE
5-8 PC208W, Version 3.0, Instruction Manual
5.4.1 PROGRAM LOCATION
There are eight memory locations available.
The Program Status box will either:
• Display a number indicating the starting
position in memory of the program
(CSM1/MCR1 and PC Card),
• Say “Used” for a program in a specific
location (SM192/716),
• Say “Free” for an unused location.
A program location is selected by clicking on it
to highlight its checkbox. Once you have
selected the program location(s) you can carry
out the desired action by clicking on one of the
three buttons.
5.4.2 CLEAR
Clicking on the Clear button will clear the
selected programs from the card or module
memory. You will be asked to confirm this
request before the program(s) are actually
cleared.
5.4.3 STORE
Clicking on the Store button will allow you to
store a program in the selected program
location. If a program already exists in this
location, you will be asked to confirm that it can
be overwritten. Once a valid location has been
selected, a Program Selection box appears
showing any valid program files (.dld extension)
on the current drive and directory. You can
select any of these, or choose any other valid
program file by browsing the directory structure.
Once you have selected the required program,
it will be written to the storage card or module. A
Progress Indicator at the bottom right of the
screen will confirm that the program is being
written to the card or module.
5.4.4 READ
This is the reverse operation to the Store
request. Clicking the Read button will allow you
to read a program from the selected program
location to disk. Once a location containing a
program has been selected, clicking on the
Read button brings up a file selection menu for
you to select the location in which to store the
program on disk. A progress indicator will
confirm that the program is being read from the
card or module.
5.5 DATA
Clicking on the DATA tab will bring up the DATA
CONTROL OPTION screen as shown in Figure 5-6,
below.
FIGURE 5-6. DATA CONTROL Screen
Comma separated
ASCII with Array ID’s
As Stored
Auto Increment Name
Append to Current File
New Name for Each File