Instruction manual

SECTION 5. STG MODULE: SMS - STORAGE MODULE SOFTWARE
5-2 PC208W, Version 3.0, Instruction Manual
CSM1, SM192 or SM176 Storage Modules
must be connected to the PC with an SC532
interface, plus a 7026 or SC25PS cable. A basic
connection diagram is shown in Figure 5-2
below. The Storage Module manuals give full
details of connecting the modules to the
computer.
NOTE: The MCR1 Memory Card Reader
does not require an SC532 interface.
If your computer is fitted with a PC card reader
supporting Card Services protocol, SMS can be
used to interrogate the memory card in a similar
way to interrogating a card in the CSM1/MCR1
Storage Module. Please see Appendix D for
specifications and requirements for PC Card
support.
Start SMS by clicking on the Stg Module button.
The first time you use the program it will show
the screen for the CSM1/MCR1 Card Storage
Module as in the screen in Figure 5-3.
5.2.1 THE SETUP SCREEN
The SETUP screen shown in Figure 5-3 is used
to set the Communications (COM) Port and
Baud Rate before communications between the
module and computer are established.
12V DC
COM Port of a PC
SC532
Storage Module
AC/DC
Adaptor
or
7026 or
SC25PS
Cable
SC12
Cable
FIGURE 5-2. Connecting the Storage Module to a PC using an SC532 Interface
FIGURE 5-3. Typical SETUP Screen and StatusBox for the CSM1/MCR1 Module