Instruction manual

x SC932A Interface – required if connecting the modem to the CS I/O port

of a datalogger.

If you have a black SC12 cable that is not Rev1 or newer (indicated on cable), it

is a CS I/O cable and will not work for RS-232. Connect the black SC12 cable

between the datalogger and the SC932A. Use a 9pin serial cable or a blue ribbon

cable between the modem and the SC932A

5.3 Configuration

5.3.1 Support Materials

Supporting documentation is available for download from the Campbell

Scientific (Canada) website. If you are configuring the modem via a USB

connection, download and install the USB driver prior to connecting the

modem to your computer:

http://www.campbellsci.ca/19_1_1019

5.3.2 Getting Started

1. SIM card – insert the card in the correct orientation into the slot located on

the front of the modem. You will know the card is properly installed when

you hear the card click into place.

2. Antenna – connect the antenna to the “antenna” jack on the back of the

modem. This should be done prior to applying power.

NOTE