Instruction manual

HS2 and HS2P

filtered and charted by the computer software based on the zone in which the

data was collected.

The HydroSense II keeps a table of up to 100 GPS zones in memory and

searches through this table every few seconds to determine if it is within the

boundary of a zone. When it has determined that the user is within a zone, it

displays the zone name on the main screen (p. 14).

Zones can be created when data are stored. When the Store (p. 14) button is

pressed, and the HydroSense II determines that the current location is not in an

existing zone, CREATE A NEW ZONE? is displayed.

To create a new zone, select YES and press . To exit without storing,

press .

When a new zone is created, the following screen is displayed.

Use the buttons to select the radius to use for this zone and press

to save the new zone details. Press to return to the main screen (p. 14)

without creating a new zone and without storing data.

Once a zone is created, the water content data will be stored. By default the

zone name will be in the form “Zone xxxxx” where xxxxx is a number that

automatically increases each time a new zone is created. Zones can be

renamed and updated using HydroSense II Support Software.