Instruction manual
Table Of Contents
- Revision and Copyright Information
- Limited Warranty
- Assistance
- Precautions
- Table of Contents
- 1. Introduction
- 2. Cautionary Statements
- 3. Initial Inspection
- 4. Quickstart
- 5. Overview
- 6. Specifications
- 7. Installation
- 8. Sensor Maintenance
- 9. Troubleshooting
- 10. References
- Appendix A. Importing Short Cut Code
- Appendix B. Example Programs
- Appendix C. Interfacing with HMP155A RS-485 Output
- Campbell Scientific Companies
HMP155ATemperature and Relative Humidity Probe
4. Select Datalogger Model and Scan Interval (default of 5 seconds is
OK for most applications). Click Next.
5. Under the Available Sensors and Devices list, select the Sensors |
Meteorological | Relative Humidity & Temperature | HMP155
folder. Select HMP155 (constant power) or HMP155 (panel
switched power) (shown). Click to move the selection to the
Selected device window. The temperature defaults to degrees
Celsius. This can be changed by clicking the Temperature box and
selecting one of the other options.
6