User manual

Hukseflux Thermal Sensors
HFP01SC Manual v0811 page 22/33
4 Short user guide
Preferably one should read the introduction and the section on
theory. Really important items are put in boxes.
The sensor should be installed following the directions of the
next paragraphs. Essentially this requires a data logger and
control system capable of switching, readout of voltages, and
capability to perform calculations based on the measurement.
The first step that is described in paragraph 5 is and indoor test.
The purpose of this test is to see if the system works. It can be
done in a very simple way.
The second step is to make a final system set-up. This is
strongly application dependent, but it usually involves complete
programming and automation of the system.
Directions for this can be found in paragraphs 6 to 12.