Programming instructions

38 Designer’s Guide
Calsense
user-set limit. As wind subsides, the ET2000e controller resumes irrigation where it left off. It can
accurately read winds from 0 to 135 MPH.
The Wind Gage cannot share data with other controllers through the Calsense Command Center Central
Water Management Software; however, it can be shared using the FLOWSENSE® option.
Figure 17 - Wind Gage
Wind Gage Cable
The Wind Gage is shipped with 60 feet of two-conductor cable. The maximum length of cable is 1,000
feet using Paige P7171D communication cable. For runs under 100 feet, 18-gauge multi-conductor
irrigation wire, in conduit, may be substituted. It is highly recommended that the cable be installed in
conduit, to connect the Wind Gage to a controller with the -WG interface. Runs are to be direct pulls
without splices.