Specifications

CR3000 Overview
Clicking the Factory Defaults button on the Settings Editor will send a
command to the device to revert to its factory default settings. The reverted
values will not take effect until the final changes have been applied. This
button will remain disabled if the device does not support the DevConfig
protocol messages.
If, after changing a setting or clicking the Summary button, you clicked Save
on the summary screen to save the configuration, you can use the Read File
button to load those settings. The settings from the saved file are immediately
sent to the device and, if they’re accepted, you can then Apply them.
OV4. Quick Start Tutorial
OV4.1 Software Products for the CR3000
PC200W Starter Software supports a direct connection between the PC and the
CR3000, and includes Short Cut for Windows (Short Cut) for creating CR3000
programs. PC200W provides basic tools for setting the datalogger’s clock,
sending a program, monitoring sensors, and manually collecting and viewing
data. CR3000 support was added to PC200W in Version 3.1. PC200W is
available at no charge from the Campbell Scientific website.
PC400 Datalogger Support Software (mid-level software) supports a variety of
telecommunication options, manual data collection, and data display. PC400
includes Short Cut and the CRBasic Program Editor for creating CR3000
programs. PC400 does not support combined communication options (e.g.,
phone-to-RF), PakBus® routing, or scheduled data collection. CR3000
support was added to PC400 in Version 1.3.
OV-23