Specifications

Section 8. CR1000 Configuration
8-2
FIGURE 8.1-1. DevConfig CR1000 Facility
When the Connect button is pressed, the device type, serial port, and baud rate
selector controls become disabled and, if DevConfig is able to connect to the
CR1000, the button will change from "Connect" to "Disconnect".
8.2 Sending the Operating System
8.2.1 Sending OS with DevConfig
The CR1000 is shipped with the operating system pre-loaded. However, OS
updates are made available at www.campbellsci.com and can be sent to the
CR1000. Using DevConfig to send an operating system is described below
using FIGURE 8.2-1.
Sending
an operating system with DevConfig will erase all
existing data and reset all settings to factory defaults.
CAUTION