Specifications

B-1
Appendix B. Status Table
The CR1000 status table contains system operating status information
accessible via CR1000KD keypad or PC software DevConfig, LoggerNet, or
PC400. TABLE B-1 lists some of the more common uses of status table
information. TABLE B-2 is a comprehensive list of status table variables with
brief descriptions.
Status Table information is easily viewed by going to LoggerNet | Connect |
Datalogger | View Station Status. However, be aware that information
presented in View Station Status is not automatically updated. Rather, click
the refresh button each time an update is desired. Alternatively, use the
Numeric displays of the connect screen to show critical values and have these
update automatically, or use Devconfig, which polls the status table at regular
intervals without use of a refresh button. Note that a lot of comms and other
activity is needed to generate the Status Table, so if the CR1000 is very tight
on time, just getting the Status Table itself repeatedly could push timing over
the edge and cause skipped scans.
TABLE B-1. Common Uses of the Status Table
Feature or Status Field Feature or Status Field
Suspect Constituent to Consult Suspect Constituent to Consult
Full Reset of CR1000 FullMemReset (Enter 98765) PakBus IsRouter
Program Execution BuffDepth
MaxBuffDepth
Operating System OSVersion PakBusNodes
OSDate CentralRouters
OSSignature Beacon
WatchdogErrors Verify
Power Supply Battery MaxPacketSize
WatchdogErrors CRBASIC Program ProgSignature
Low12VCount Compile Results
Low5VCount ProgErrors
StartUpCode VarOutofBound
SRAM LithiumBattery SkippedScan
MemorySize SkippedSlowScan
MemoryFree PortStatus
Telecommunications PakBusAddress PortConfig
Low5VCount Measurements ErrorCalib
RS-232Handshaking Data SkippedRecord
RS-232Timeout DataFillDays
CommActive
CommConfig
Baudrate