Specifications

Section 8. CR1000 Configuration
8-8
8.3.1.2 Ports Settings Sub-Tab
As shown in FIGURE 8.3-4, the port settings tab has the following settings.
FIGURE 8.3-4. DevConfig Deployment | Ports Settings Tab
Read more! PakBus Networking Guide available at www.campbellsci.com.
Selected Port specifies the datalogger serial port to which the beacon interval
and hello setting values will be applied.
Beacon Interval sets the interval (in seconds) on which the datalogger will
broadcast beacon messages on the port specified by Selected Port.
Verify Interval specifies the interval (in seconds) at which the datalogger will
expect to have received packets from neighbors on the port specified by
Selected Port. A value of zero (default) indicates that the datalogger has no
neighbor list for this port.
Neighbors List, or perhaps more appropriately thought of as the “allowed
neighbors list”, displays the list of addresses that this datalogger expects to find
as neighbors on the port specified by Selected Port. As items are selected in
this list, the values of the Begin and End range controls will change to reflect
the selected range. Multiple lists of neighbors can be added on the same port.
Begin and End Range are used to enter a range of addresses that can either be
added to or removed from the neighbors list for the port specified by Selected
Port. As users manipulate these controls, the Add range and Remove Range
buttons will be enabled or disabled depending on the relative values in the
controls and whether the range is present in or overlaps with the list of address