Instruction manual

CS650 and CS655 Water Content Reflectometers

8.1.2.1 Settings Editor Tab

The Settings Editor tab shows settings stored in the CS650 firmware. Settings

that may be modified include User Name, SDI-12 Address, and RS-232 Baud

Rate. Attempts to change any of the other settings will result in a “Commit

failed. Unrecognized error condition” error message. DevConfig polls the

CS650 every two seconds while connected and the results are displayed in the

Real-Time Measurements field (TABLE 8-2). This is useful for verifying

probe performance.

Default communication settings are 9600 baud, no parity, 1 stop bit, 8 data bits,

and no error checking. After any changes to CS650 settings, select Apply to

write the changes to the CS650 firmware. A configuration summary is then

shown. The summary may be printed or saved electronically for future

reference.