Instruction manual

CS650 and CS655 Water Content Reflectometers
8.1.2 Device Configuration Utility (DevConfig)
DevConfig may be downloaded from the Campbell Scientific website,
www.campbellsci.com/downloads.
Connect the CS650 to the A200 as shown in TABLE 8-1. Connect the PC to
the A200 USB port with the supplied USB cable.
Launch DevConfig and select CS650 Series from the Device Type menu on
the left. Select 9600 from the Baud Rate drop-down menu.
Select the appropriate PC serial port from the list of available COM ports
shown when the browse button on the lower left is selected (see Section
8.1.1.4, Determining which COM Port the A200 has been Assigned
(p. 13)).
Select Ok and then Connect to begin communication with the CS650.
14