Instruction manual

CS451/CS456 Submersible Pressure Transducer

package (e.g., LoggerNet) before and after the installation, or look in the

Windows Device Manager list under the ports section (access via the control

panel).

8.1.2 Device Configuration Utility (version 2.03 or higher)

The Device Configuration Utility (DevConfig) allows you to change the

settings of the CS451/CS456. DevConfig is shipped on the Campbell Scientific

ResourceDVD included with the CS451/CS456.

To use DevConfig, the transducer needs to be connected to the PC via the A200

(see Section 8.1.1, PC Connection Using the A200

(p. 13)). After installing

DevConfig and connecting the transducer to the PC, select CS451 from the

Device Type list on the left column of the screen.

In the PC Serial Port box, select the COM port that was assigned to the A200

(see Section 8.1.1.4, Determining which COM Port the A200 has been

Assigned

(p. 14)). Click on the Connect button to enable communication with

the sensor. Once successfully connected, the screen should look like FIGURE

8-2.

FIGURE 8-2. Connect screen

There are three settings that can be changed: SDI-12 address, Pressure/Level

Units, and Temperature Units. Double-click on the window of the units to be

changed. This will open a pick menu box. Select the desired units and Apply

the changes.