Instruction manual

Table of Contents

Appendices

Importing Short Cut Code Into CRBasic Editor ... A-1

A.1 Importing Short Cut Code into a Program Editor ............................ A-1

A.1.1 CRBasic Datalogger ................................................................. A-1

A.1.2 Edlog ........................................................................................ A-2

B. Example Programs .................................................. B-1

B.1 CRBasic Programs .......................................................................... B-1

B.1.1 Example CR200(X) Program ................................................... B-1

B.1.2 Example Program for CR800, CR850, CR1000, CR3000,

or CR5000 ............................................................................. B-2

B.2 Edlog Program................................................................................. B-3

C. Environmental Performance .................................. C-1

C.1 Tests to Defined Standards .............................................................. C-1

C.2 Exposure to Pollutants ..................................................................... C-1

C.3 Operating Range of RH Element ..................................................... C-2

C.4 Measurement Below 0 °C ............................................................... C-2

D. SDI-12 Sensor Support ........................................... D-1

D.1 SDI-12 Command Basics ................................................................ D-1

D.1.1 Address Query Command (?!) ................................................. D-2

D.1.2 Change Address Command (aAb!) .......................................... D-2

D.1.3 Send Identification Command (aI!) .......................................... D-2

D.1.4 Start Measurement Commands (aM!) ...................................... D-2

D.1.5 Aborting a Measurement Command ........................................ D-2

D.1.6 Send Data Command (aD!) ...................................................... D-2

D.2 SDI-12 Transparent Mode ............................................................... D-2

D.2.1 CR200(X) Series Datalogger Example .................................... D-3

D.2.2 CR1000 Datalogger Example ................................................... D-4

D.2.3 CR10X Datalogger Example .................................................... D-5

Figures

7-1. CS215 and 41303-5A Radiation Shield on a tripod mast .................... 9

7-2. CS215 and 41303-5A Radiation Shield on a CM200 Series

Crossarm .......................................................................................... 9

9-1. Correct fit of sensor element (side view)........................................... 15

9-2. Incorrect fit of sensor element (side view) ........................................ 16

C-1. Normal operating conditions of RH element ................................... C-2

D-1. CR200(X) example of using the SDI-12 transparent mode to

change the SDI-12 address from 0 to 1. ....................................... D-3

D-2. CR1000 example of using the SDI-12 transparent mode to

change the SDI-12 address from 3 to 1. Sensor is connected

to control port 1. ........................................................................... D-4

D-3. CR10X example of using the SDI-12 transparent mode to

change the SDI-12 address from 0 to 1. Sensor is connected

to control port 1. ........................................................................... D-5