Instruction manual

CFM Compact Flash Module
PROGRAM
'CR1000
Public temp
DataTable (Table1,1,-1)
CardOut (0, -1)
Maximum (1,temp,FP2,False,False)
Minimum (1,temp,FP2,False,False)
EndTable
BeginProg
Scan(1,SEC,3,0)
PanelTemp(temp,250)
CallTable Table1
NextScan
EndProg
3.2.2 Fill and Stop Mode
The following program outputs a sample of the panel temperature to the card once
a second. The first parameter of the CardOut instruction is 1, which sets the table
on the card to fill and stop mode. The second parameter (1000) is the number of
records which will be written before the table is full and data storage stops. Once
1000 records have been stored, data storage will stop.
PROGRAM
'CR1000
Public temp
DataTable (Table1,1,1000)
CardOut (1,1000)
Sample(1,temp,IEEE4)
EndTable
BeginProg
Scan(1,SEC,3,0)
PanelTemp(temp,250)
CallTable Table1
NextScan
EndProg
To reset a table after a fill and stop table has been filled and stopped, either use
the reset button in LoggerNet (LN Connect | Datalogger | View Station Status |
Table Fill Times, Reset Tables button) or use the CRBasic ResetTable instruction.
3.2.3 Mixed Modes
The following program stores 4 data tables to the card. The first two tables will
output samples of the panel temperature and battery voltage to the card once a
second. The first parameter of the CardOut instructions is 1, which sets the tables
on the card to fill and stop mode. The second parameter is 1000, so 1000 records
will be written to each table before stopping.
3-2