User guide
C-1
Appendix C. Unlocking a SIM Card
There are two methods to unlock a SIM Card, and the equipment you have
available will dictate which method is used.
C.1 Handset Method
To unlock the Iridium SIM card permanently using the Iridium Handset follow
these instructions.
Install the SIM card, attach the antenna, and 9522B interface. Attach the handset
as required. Apply power to the modem.
The handset will request the PIN number before proceeding. Once you enter the
PIN number (default 1111) the modem will register itself. You will need to
navigate the menus of the handset as follows:
Find “PHONE SETUP”, click ok
From this menu select “REQUIRE SIM PIN”
Navigate until “OFF” is displayed, select by clicking ok
Exit out of the menus once the PIN requirement is deactivated.
With the card unlocked you can continue with your modem setup.
C.2 Terminal Emulator Method
In order to unlock the SIM cards with this method you will need a terminal
emulator like Hyperterminal. The configuration will need to be same as list in
Section 2.2 of this manual. Refer to Section 2.2 for this setup.
Both SIM Cards must be unlocked.
When conducting these steps you will need to have the SIM Card installed in the
modem. The antenna must be connected, and have a sky view for communications
with the satellite network. Finally the unit must be powered. Refer to the
appropriate Sections of this manual for information about these requirements.
Once the modem and terminal emulator are ready enter the following command:
AT+CPIN? <Enter>
The command requests that the modem respond as to whether a password is
required. The expected modem response is:
+CPIN: SIM PIN
The response confirms that the SIM Card PIN1 code is required to unlock the
Card. If you get a different response, contact the SIM Card provider to determine
if a different code is required. If you get a response of “+CPIN: SIM PIN2” this
may mean that the Card is already unlocked or requires a different code.
The next step is to enter the PIN code for the SIM Card.
AT+CPIN=”1111” <Enter>
NOTE